35
s
s
Basic Photography and Playback
Before shooting, check the battery level and number of exposures remaining.
1
Turn the camera on.
Remove the lens cap and turn the camera on.
The control panel will turn on and the display in
the viewfinder will light.
2
Check the battery level.
Check the battery level in the control panel or viewfinder.
3
Check the number of exposures remaining.
The control panel and viewfinder show the number of
photographs that can be taken at current settings (values
over 1000 are rounded down to the nearest hundred; e.g.,
values between 1000 and 1099 are shown as 1.0 K). If two
memory cards are inserted, the displays show the space
available on the card in Slot 1 (
31). When the number of exposures
remaining reaches
A
, the number will flash,
n
or
j
will flash in the
shutter-speed displays, and the icon for the affected card will flash. Insert
another memory card (
Battery Level and Card Capacity
Control panel Viewfinder
Description
L
—
Battery fully charged.
K
—
Battery partially discharged.
J
—
I
—
H
d
Low battery.
Charge battery or ready spare battery.
H
(flashes)
d
(flashes)
Shutter release disabled.
Charge or exchange battery.
A
Image Sensor Cleaning
The camera vibrates the image sensor to remove dust when the camera is turned on or off
(
Summary of Contents for D7100
