5
Attaching the WR-R11a/WR-R11b (Transceiver)
To use the WR-R11a/WR-R11b, attach it to a compatible camera.
D
Before Attaching the WR-R11a/WR-R11b
•
Be sure the camera is off before proceeding.
•
For information on cameras that can be used with the WR-R11a/
WR-R11b, see “Specifications” under “supported cameras” (
40).
Attaching the WR-R11a
Connect the WR-R11a to the camera’s 10-pin remote terminal
(
q
) as shown by the mounting marks on the WR-R11a (
d
) and
camera (
b
) and tighten the WR-R11a locking screw (
w
).
D
Aligning the Mounting Marks
After attaching the controller, angle it so that the mounting marks align as
shown (
e
). Failure to observe this precaution could cause damage or
product malfunction.
Attaching the WR-R11a/WR-R11b
(Transceiver)
Summary of Contents for WR-T10
Page 59: ......