Maintenance
XT V 160 X-ray System
XTM0011-F2
65
microscope, make sure that the focus cup is parallel to the lens of the magnifying glass or
microscope to avoid parallax errors.
Viewing from the wrong angle is a very common mistake when centring the filament:
Parallax affecting the position
of the filament
Filament not centred,
but viewed correctly
Filament off centre
Summary of Contents for XT V 160
