386
Troubleshooting
Solutions to some common issues are listed below.
Battery/Display
Problems and Solutions
The camera is on but does not respond
: Wait for recording to end. If the
problem persists, turn the camera off. If the camera does not turn off,
remove and reinsert the battery or, if you are using an AC adapter,
disconnect and reconnect the AC adapter. Note that although any data
currently being recorded will be lost, data that have already been
recorded will not be affected by removing or disconnecting the power
source.
The viewfinder or monitor does not turn on
: Choose a different monitor mode
using the monitor mode button.
The viewfinder is out of focus
: Rotate the diopter adjustment control to focus
the viewfinder. If this does not correct the problem, select
AF-S
, single-
point AF, and the center focus point, and then frame a high-contrast
subject in the center focus point and press the shutter-release button
halfway to focus the camera. With the camera in focus, use the diopter
adjustment control to bring the subject into clear focus in the
viewfinder.
The displays turn off without warning
: Choose longer delays for Custom
Setting c3 (
Power off delay
).
The control panel is unresponsive and dim
: Control panel response times and
brightness vary with temperature.
Summary of Contents for Z 6
Page 495: ......
