This document may be subject to change
Side 19 of 24
Preset
The PRESET menu allows default factory settings to be stored.
RESTORE menu allows you to reload a copy of the installation setup.
By keeping the ESC +
key pressed for 5 seconds a new menu item RESTORE appear, this is
then acceptable / activated by pressing the ENTER
Options that flash are indicated by
” ”
On the CTS602 control panel, press:
- ESC to return to the previous menu
-
p
to scroll upwards or downwards through the menus or to
adjust the setting of an activated menu option
- ENTER to activate a menu option
- ENTER to confirm a menu option setting
- OFF switch off the controls
- ON to switch on the controls
INLET
HEATING
AIR
EXCHANGE
DEFROST
INLET
CONTROL
SERVICE
ENTER
TEMP.
CONTROL
MANUAL
OFF
ROOM
CONTROL
RESTART
OFF
PRESET
OFF
ENTER PRESET
OFF
PRESET
STANDARD
When ”standard” is
chosen all factory
settings are reset. An
eventual supplementary
heating surface must be
re-activated.
frost-protected until it is
correctly installed and
activated in the service
menu.
AIR
QUALITY
”BACKUP”
”RESTORE”
PRESET
PRESET
The backup will be
saved.
The backup is restored.
Subsequently, the
system must be
restarted.
MODBUS
ADR 30
DATALOG
INTV 10
HEAT
SURFACE
Figure 16: The "Preset" Menu
