ENGLISH
- 7
6.1.d - Using the machine
(Fig. 17)
- After starting the machine, begin cleaning
by keeping the levers (29) pressed, thus
keeping the machine running and brush
rotation active.
DANGER:
During operation, avoid passing over the
power cable with the machine: this could
cause serious damage and dangerous
situations!
NOTE:
Using the machine in a fixed position with the
pad rotation enabled for a prolonged period of
time can cause damage to the floor.
NOTE:
When the levers (29) are released, pad rotation
stops and the machine turns off
6.1.e - Use with overturned handle
(Fig. 21)
- Partially raise the handle (2) and unlock
the pusher tags (34) with one foot.
- Slowly rotate the handle (2) until it auto-
matically locks through the pusher tags
(34).
- Adjust the handle (2) height through the
lever (3) depending on your needs.
6.1.f – End of use and shutdown
(Fig. 17-22-23).
- Release the levers (29) to stop pad rota-
tion and turn off the machine (Fig. 17).
- Put the handle in an upright position.
- Remove the tank (Optional), empty the
solution and clean the nozzle as indicat-
ed in the maintenance paragraph.
WARNING:
Do not leave the machine stopped if the
pad is mounted and not raised in order to
prevent them from being damaged.
- Unplug the power cable from the socket
and wrap it around the cable reel sup-
ports.
- Roll up the cable on the supports (11)
(12) (Fig. 22).
- To remove the cable from the supports,
turn the hooks (11) (12) inward and re-
move the cable without necessarily un-
winding it (Fig. 23).
6.1.g - Transport (Fig.24)
Making sure that the mains plug is discon-
nected and the handle is in an upright posi-
tion, lift the machine body by turning the han-
dle downwards.
The machine can then be transported on the
wheels.
If it is necessary to lift the machine for load-
ing on trucks or for climbing stairs, proceed
as follows:
- Release the two pusher tags (34) and,
through the handle (7), slightly move the
head so that the two pusher tags hook
correctly.
- Two persons must raise the machine:
one on the guide handle (2) and the other
through the handle (7).
7.1 MAINTENANCE AND
CLEANING
WARNING:
For information and warnings relating
to maintenance or cleaning, follow what
is described in the “Safety warnings for
single disc” manual, accompanying this
document.
Summary of Contents for 1691005
