Programming
Overview
The IntelliPad system is programmed in six
fundamental stages:
1. Teach all of the preamp/receiver IR com-
mands onto the System page.
2. Teach each of the source component IR com-
mands onto the Source Pages.
3. Teach a secondary IR command onto the
Press and Hold Page.
4. Configure sequences of preprogrammed IR
commands and/or delays to trigger from any
or all keys (except the Power key) on all
pages (including the Press and Hold page).
5. Permanently archive the program you have
created on a PC using the optional IntelliFile
PC Transfer and Storage System.
6. Transfer the program to any additional
IntelliPads in the system.
Ground Rules and Guidelines
Erasing the Entire Memory Before You Start
Before beginning to program the IntelliPad,
erase any earlier programs by following these
steps:
1. Press the PROGRAM button. The PROGRAM
LED, the IR/SEQ LED and the PAGE LED light
up red.
2. Press and hold the ERASE button until all the
Prompt LEDs flash, then release. The PRO-
GRAM LED begins to flash, warning you that
you are about to erase.
3. Press and hold the ERASE button until all the
Prompt LEDs flash. This erases the entire
memory of the IntelliPad.
4. To exit the Program mode, press the
PROGRAM button once.
17
W
A L L
M
O U N T E D
P
R O G R A M M A B L E
I R K
E Y P A D
S
Y S T E M
DS00154A/IntelliPad 2/5/99 4:32 PM Page 13
