25
W
A L L
M
O U N T E D
P
R O G R A M M A B L E
I R K
E Y P A D
S
Y S T E M
Transferring Programs
Overview
The IntelliPad allows you to transfer programs
between two IntelliPads. You must supply
power to one of the IntelliPads. The other
IntelliPad will get its power via the transfer
cable.
Parts Required
To transfer between IntelliPads you only need
the supplied transfer cable and a 12v DC power
supply.
Transferring Programs From One IntelliPad
to Another
Follow these steps in order:
1.
Program all the IR commands and sequences
on one IntelliPad.
2. Test. Make sure that all codes and sequences
work as you desire.
3. Connect the IntelliPad to 12v DC power. Use
the 12v+ and GND connectors of the IR
DATA connector located on the rear of the
IntelliPad.
4. Connect the the Transfer cable to the transfer
sockets on both IntelliPads.
5.
Press the PROGRAM button on both IntelliPads.
The PROGRAM LEDs, IR/SEQ LEDs and PAGE
LEDs light on both IntelliPads.
6.
Press the TRANSFER key on both IntelliPads.
The Transfer LED lights on both IntelliPads.
7.
ON THE BLANK INTELLIPAD ONLY, press any
key. The transfer LED blinks on both
IntelliPads until the transfer is successfully
completed, then both LEDs go out, returning
you to normal operation.
IntelliFile
®
PC Storage and
Transfer System
The IntelliFile is an optional IntelliPad accessory
which enables your Niles dealer to store
IntelliPad programmed memory to an IBM or
compatible personal computer running
Microsoft Windows as the operating system. If
needed, the memory files can also be down-
loaded to an IntelliPad.
The IntelliFile System consists of a storage/trans-
fer program, PC Interface, power supply, and a
cable adapter kit.
DS00154A/IntelliPad 2/5/99 4:32 PM Page 5
