Mounting Location
Convenient mounting locations for the TVC-1 are:
• With other stereo components
• Near a desk
• At your bedside
• Close to a telephone
Installation
1. Select a convenient location for the TVC-1.
2. Run all the necessary wiring to the TVC-1. Label the wires
for future reference. See (Figure 1).
3. Locate the connector plugs (and remove them if they are
plugged in). See Figure 6.
4. Strip 1/4" of insulation from the end of each wire. Tightly
twist the end of each wire until no frayed ends remain.
5. Use a small flathead screwdriver or your thumbnail to raise
the locking tabs, exposing the holes on the removable con-
nector plug.
5
T
A B L E T O P
S T E R E O
V
O L U M E
C
O N T R O L
“TECH TIP”
Wire size is expressed
by it’s AWG
(American
Wire Gauge)
number. The lower
the AWG number,
the larger the wire,
i.e., 12 AWG wire
is physically larger
than 14 AWG.
Summary of Contents for TVC-1
Page 13: ......
