Wheel System - Traction
124
Service Manual – SC1500
7
Remove the four
M8 x 45 Screws
and flat washers,
then remove the
Drive Wheel Assembly
and attached
Spindle Mount Weldment
from the machine.
8
To reinstall the
Drive Wheel Assembly
and attached
Spindle
Mount Weldment
, follow the above steps in reverse order.
Service Tip:
Make sure the axes of the two
Universal Joints
are parallel when
you reconnect the
Steering
Assembly Tube
to the
Lower
Universal Joint
. If the two
Universal
Joints
are “out of phase”, the
steering system will bind.
Spindle
Mount
Weldment
M8 x 45
Screw (4)
Drive
Wheel
Assembly
M8 x 45
Screw (4)
Spindle
Mount
Weldment
Drive
Wheel
Assembly
Machine lying on its side
Upper
Universal
Joint
Hex
Shaft
Steering
Assembly
Tube
Lower
Universal
Joint
Upper
Universal
Joint
Hex
Shaft
Steering
Assembly
Tube
Lower
Universal
Joint