Scrub System
91
Service Manual – SC1500
14
Disconnect the
Scrub Deck Motor Electrical
Connector
15
Carefully slide the deck out of the machine.
Service Tip:
The scrub motors on the
20R REV™ scrub decks are slightly
taller than the motors on 20D decks.
When you remove a 20R REV™ scrub
deck you’ll need to jack up and block the
front of the machine slightly in order
to get adequate clearance to remove the
deck from the machine.
16
Reinstall the deck by following the above steps in
reverse order.
Caution:
Note that the scrub deck actuator will automatically raise the scrub deck when you
reconnect the
Actuator Electrical Connector
.
Service Tip:
When you reinstall
the scrub deck, make sure you
have all 16
Link Arm Bushings
and all eight
12mm Flat Washers
installed in the
Link Bar
and
Linkage Bars
before reinstalling
the
Shoulder Bolts
and
Nyloc
®
Nuts
.
Scrub Deck Motor
Electrical
Connector
Link Bar
Link Arm
Bushing (16)
12mm Flat
Washer (8)
Shoulder
Bolt (8)
Linkage
Bar (2)
Nyloc
Nut (8)