General Information
10
Service Manual – SC1500
Prop Rod
To prevent the
Control Panel Housing / Recovery
Tank Cover
from dropping unexpectedly and
causing injury, always engage the
Prop Rod
as
shown before working under the
Panel Housing
/ Recovery Tank Cover
Moving the Machine
The drive wheel motor has a built-in
electromagnetic brake that engages whenever
the Key Switch is Off or the Go Pedal is
released. You can manually override this
brake if necessary by reaching up around the
back of the front drive wheel and rotating the
Brake Arm
up as shown. This should only be
done if you need to push or pull the machine.
Remember to reengage the
Brake Arm
once you
finish moving the machine.
Note:
Turn the drive wheel 45° to the right
for easier access to the
Brake Arm
.
Control Panel
Housing/
Recovery
Tank Cover
Prop Rod
(engaged)
Brake
Arm
Brake
Arm
