ENGLISH / A-11
FORM NO. 56091001 - BR 1100S SBG SPECIAL -
A-11
DETERGENT SYSTEM PREPARATION AND USE (ECOFLEX MODELS ONLY)
COMMON INSTRUCTIONS:
Pressing and releasing the Detergent Switch
(J)
while the solution system is active will cause the detergent system to alternately turn on and off. The system
should be purged of previous detergent when switching to a different detergent.
SERVICE
NOTE:
Move machine over
fl
oor drain before purging because a small
amount of detergent will be dispensed in the process.
To Purge When Changing Chemicals:
1
Disconnect and remove the detergent cartridge.
2
Turn the Key Switch
(A)
ON. Press and hold the Solution Switch
(F)
and the Detergent Switch
(J)
down for 3 seconds.
NOTE:
Once activated the purge
process takes 10 seconds. See illustration on next page for Detergent System indicators. Normally one purge cycle is adequate to purge the system.
To Purge Weekly:
1
Disconnect and remove the detergent cartridge. Install and connect a Cartridge
fi
lled with clean water.
2
Turn the Key Switch
(A)
ON. Press and hold Solution Switch
(F)
and the Detergent Switch
(J)
down for 3 seconds.
NOTE:
Once activated the purge
process takes 10 seconds. See illustration on next page for Detergent System indicators. Normally one purge cycle is adequate to purge the system.
Detergent Percentage:
1
The detergent percentage default is 0.25%. To change the percentage, the detergent system must be OFF, then press and hold the Detergent ON/OFF
Switch
(J)
for 2 seconds. The detergent indicator will
fl
ash and each press of the switch will cycle through the available percentages (3%, 2%, 1.5%, 1%,
0.8%, 0.66%, 0.5%, 0.4%, 0.3%., 0.25%). Once the desired percentage is displayed on the screen
(K9)
, stop and it will lock in after 5 seconds.
CARTRIDGE INSTRUCTIONS:
The Detergent Cartridge
(29)
is located behind the Side Access Panel
(27)
. Fill the detergent cartridge with a maximum of 2.2 gallons (8.32 Liters) of detergent.
SERVICE NOTE:
Remove the detergent cartridge from the detergent box prior to
fi
lling to avoid spilling detergent on the machine.
It is recommended that a separate cartridge be used for each detergent you plan to use. The detergent cartridges have a white decal on them so you can write the
detergent name on each cartridge to avoid mixing them up. The system should be purged of previous detergent when switching to a different detergent. When
installing a new cartridge, remove the Cap
(AA)
and place the cartridge in the detergent box. Install the Dry Break Cap
(BB)
and detergent hose as shown.
FIGURE 5
