A-8 / ENGLISH
A-8
- FORM NO. 56091001 - BR 1100S SBG SPECIAL
INSTALL THE BRUSHES (CYLINDRICAL SYSTEM)
CAUTION!
Turn the key switch off (O) and remove the key, before changing the brushes, and before opening any access panels.
1
Make sure the Scrub Deck is in the RAISED position. Make sure the Key Switch
(A)
is off (O).
2
See Figure 2.
Remove both side skirt assemblies.
NOTE:
The skirts are held in place by two large Knobs
(AA)
. Loosen these knobs, slide the Skirt
Assemblies
(BB)
forward slightly and then off of the Scrub Deck.
3
Loosen the Black Knobs
(CC)
on top of the Idler Assemblies
(DD)
until they drop down far enough to disengage from the Notches
(EE)
and remove.
4
Slide the brush into the housing, lift slightly, push and turn until it seats. Re-install the Idler Assemblies
(DD)
and Skirt Assemblies
(BB)
.
FIGURE
2