INSTRUCTIONS FOR USE
9096910000(1)2006-09
15
BEFORE MACHINE START-UP
Deck installation/removal
The machine can be equipped with either the brush/pad-holder deck (18a and 18b) or the cylindrical brush deck (18c).
For deck installation/removal see the procedure in the Maintenance chapter.
Brush/pad-holder installation/removal
1.
According to the kind of cleaning to be carried out, the machine can be equipped either with brushes (A, Fig. 2) or
pad-holders (B) with pads (C) together with the appropriate deck.
2.
Turn the ignition key (80) to “0” position.
If equipped, turn the speed adjuster (84) to idle by turning it counter-clockwise.
3.
Place the brushes (A) or the pad-holders (B) under the appropriate deck (18a) or (18b).
4.
Lower the deck on the brushes/pad-holders by pressing the pedal (11).
5.
Turn the ignition key (80) to “I” position.
6.
Press the brush/pad-holder and vacuum system switch (71).
7.
Slightly press the paddle (83) forward to engage the brushes/pad-holders, then release it. If necessary, repeat the
procedure until the brushes/pad-holders are engaged.
S311317
Figure 2
8.
To remove the brushes/pad-holders, the deck must be lifted by pressing the pedal (11), then press the switch (75) and
wait for the brushes/pad-holders to fall on the floor.
Turn the ignition key (80) to “0” position.
Types of brushes available
NOTE
When the deck is installed/removed, it may be necessary to change the squeegee too, because they must
have the same width. For correct matching of deck and squeegee, see the Squeegee Installation paragraph.
WARNING!
Do not press the paddle (83) completely, otherwise the machine will start.
A light pressure on the paddle (83) is enough to engage the brushes/pad-holders and activate the
brush/pad-holder motors.
12.0 in (305 mm) models
20.9 in (530 mm) models
08603842 - Prolene
08837025 - Prolene
08603872 - Midlite Grit 180
08837028 - Midlite Grit 180
08603873 - Midgrit 240
08837029 - Midgrit 240
08603874 - Prolite
08837026 - Prolite
08603875 - Union Mix
08837027 - Union Mix