INSTRUCTIONS FOR USE
18
9096910000(1)2006-09
MACHINE START AND STOP
Starting the machine
1.
Prepare the machine as shown in the previous paragraph.
2.
Turn the ignition key (80) to “I” position.
Check that the green warning light (81a) turns on (charged batteries).
If the yellow or red warning light (81b or 81c) turns on, turn the ignition switch back to “0” position and charge the batteries
(see the procedure in the Maintenance chapter).
3.
Drive the machine to the working area, by keeping the hands on the handlebar (2) and pressing the paddle (83) forward
to move forward, and backwards to move in reverse.
The maximum forward speed can be adjusted with the adjuster (84).
4.
Lower the squeegee (25) with the lever (10).
5.
Lower the brush/pad-holder deck by pressing the pedal (11).
6.
Press the brush/pad-holder and vacuum system switch (71).
7.
Press the washing water flow control switches (82) as necessary, depending on the type of cleaning to be carried out.
8.
Start cleaning, by moving the machines as shown in step 3. If necessary, adjust the maximum speed with the adjuster (84).
Stopping the machine
9.
Stop the machine by releasing the paddle (83).
10.
Turn off the brushes/pad-holders and the vacuum system by pressing the switches (71) and (73).
11.
Lift the brush/pad-holder deck by pressing the pedal (11).
12.
Lift the squeegee (25) with the lever (10).
13.
Make sure that the machine cannot move independently.
MACHINE OPERATION (SCRUBBING/DRYING)
1.
Start the machine as shown in the previous paragraph.
2.
If necessary, press the washing water flow control switches (82) as necessary, depending on the type of cleaning to be
carried out.
3.
If necessary, stop the machine and adjust the balancing handwheel (27) of the squeegee (25).
Detergent flow adjustment
(For X20D, X20C, X24D)
To check the actual setting of the detergent percentage to be added to the washing water, perform the following procedure:
1.
Turn off the flow control switch (A, Fig. 4) [the warning light (B) must be off].
2.
Press and hold the flow control switch (A). 3 seconds after pressing the switch, the indicator (C) turns on, thus indicating
the percentage, as shown in the figure.
CAUTION!
To avoid any damage to the floor surface, turn off the brushes/pad-holders when the machine stops in one
place, especially when the extra pressure function is on.
