INSTRUCTIONS FOR USE
2
9096910000(1)2006-09
INTRODUCTION
MANUAL PURPOSE AND CONTENTS
The purpose of this Manual is to provide the operator with all necessary information to use the machine properly, in a safe and
autonomous way. It contains information about technical data, safety, operation, storage, maintenance, spare parts and
disposal.
Before carrying out any procedure on the machine, the operators and qualified technicians must read this Manual carefully.
Contact Nilfisk-Advance in case of doubts regarding the interpretation of the instructions and for any further information.
TARGET
This Manual is intended for operators and technicians qualified to perform the machine maintenance.
The operators must not carry out procedures reserved for qualified technicians. Nilfisk-Advance will not be answerable for
damages coming from the non-observance of this prohibition.
HOW TO KEEP THIS MANUAL
The Instructions for Use Manual must be kept near the machine, inside an adequate case, away from liquids and other
substances that can cause damage to it.
IDENTIFICATION DATA
The machine model and serial number are marked on the plate (34).
The machine model year is shown after the Date Code on the serial plate (A06 means January 2006).
This information is useful when requiring machine spare parts. Use the following table to write down the machine identification
data.
OTHER REFERENCE MANUALS
–
Electronic battery charger Manual to be considered as integral part of this Manual
Moreover, the following Manuals are available:
–
Service Manual (that can be consulted at Nilfisk-Advance Service Centers)
–
Spare Parts List (supplied with the machine)
SPARE PARTS AND MAINTENANCE
All necessary operating, maintenance and repair procedures must be carried out by qualified personnel or by Nilfisk-Advance
Service Centers. Only original spare parts and accessories must be used.
Contact Nilfisk-Advance for service or to order spare parts and accessories, specifying the machine model and serial number.
CHANGES AND IMPROVEMENTS
Nilfisk-Advance constantly improves its products and reserves the right to make changes and improvements at its discretion
without being obliged to apply such benefits to the machines that were previously sold.
Any change and/or addition of accessories must be approved and performed by Nilfisk-Advance.
OPERATION CAPABILITIES
These scrubber-dryers are used to clean (scrubbing and drying) smooth and solid floors, in civil or industrial environment, under
safe operation conditions by a qualified operator.
The scrubber-dryer cannot be used for moquette and carpet cleaning.
CONVENTIONS
Forward and backward, front and rear, left and right references are intended with the operator in driving position with the hands
on the handlebar (2).
NOTE
The numbers in brackets refer to the components shown in Machine Description chapter.
MACHINE model ..............................................................
MACHINE serial number ..................................................
