FORM NO. 56043097 / Adgressor
™
/ BR 850S, 850CS, 950S, 950CS, 1050S, 1050CS - 49
ELECTRICAL SYSTEM
BATTERY SPECIFICATIONS
- Use a combination of multiple 2-volt cell units (wired in series) to construct a 36 Volt DC battery pack system.
- Nilfi sk-Advance recommended battery pack capacity is a 305 or 395 AH @ 20 Hour Rate deep cycle battery system (six 6V-batteries). Note: The battery pack must
fi t the battery compartment size listed in Specifi cations.
BATTERY CHARGER SPECIFICATIONS
- Use a 36 Volt DC output charger matching the DC battery pack voltage and the input AC line voltage supply being used.
- Always when selecting a battery charger follow the recommendation of the battery supplier to match the proper charger DC output amperage to the amp/hour rating
batteries being installed. This will prevent the battery pack from being over or under charged.
- The recommended 305 AH battery should be matched to a 36V, 20 or 25 Amp charger.
- The recommended 395 AH battery should be matched to a 36V, 36 Amp charger.
INSTALL THE BATTERIES
WARNING!
Use extreme caution when working with batteries. Sulfuric acid in batteries can cause severe injury if allowed to contact the skin or
eyes. Explosive hydrogen gas is vented from inside the batteries through openings in the battery caps. This gas can be ignited by
any electrical arc, spark or fl ame.
When Servicing Batteries...
•
Remove all jewelry.
•
Do not smoke.
•
Wear chemical goggles, rubber gloves and a protective apron.
•
Work in a well-ventilated area.
•
Do not allow tools to touch more than one battery terminal at a time.
CAUTION!
Electrical components in this machine can be severely damaged if the batteries are not installed and connected properly. Batteries
should be installed by Nilfi sk-Advance or by a qualifi ed electrician.
1 Remove the batteries from their shipping crate and carefully inspect them
for cracks or other damage. If damage is evident, contact the carrier that
delivered them or the battery manufacturer to fi le a damage claim.
2 Turn the Master Key Switch (J) OFF (O) and remove the key.
3
To access the battery compartment tip the operator’s seat forward and set the
prop rod. Remove the battery cables from inside the battery compartment.
4
Your machine comes from the factory with enough battery cables to install six
(6 volt), 305 - 395 Amp hour batteries. Using two people and an appropriate
lifting strap, carefully lift* the batteries into the compartment tray exactly as
shown on machine decal (Figure 1).
5 The terminals on the battery cables are marked “+” for positive and “-“ for
negative. Install the battery cables as shown, with the terminals marked
“+” on the positive battery terminals and the terminals marked “-“ on the
negative terminals. Position the cables so the battery caps can be easily
removed for battery service.
6 Carefully tighten the nut in each battery terminal until the terminal will not
turn on the battery post. Then tighten the nut half an additional turn. Do not
over-tighten the terminals, or they will be very diffi cult to remove for future
service.
7
Coat the terminals and posts with spray-on battery terminal coating (available
at most auto parts stores).
8 Put one of the black rubber boots over each of the terminals and retain with
supplied tie straps.
9 Connect the battery pack connector to the Machine Battery Connector (22)
and close the operator’s seat platform.
*Note: Removal of the recovery tank can make battery installation easier.
FIGURE 1
Summary of Contents for Adgressor BR 1050CS
Page 81: ......
Page 82: ...www nilfisk advance com 2006 ...
