INSTRUCTIONS FOR USE
ENGLISH
9100002290 - SC401
17
09/2017
TANK EMPTYING
An automatic shut-off float system (31) turns off the vacuum system when the recovery tank (33) is full.
The vacuum system deactivation is signaled by a sudden increase in the vacuum system motor noise frequency, and the floor is not
dried.
CAUTION!
If the vacuum system turns off accidentally (for example, when the float is activated because of a sudden
machine movement), to resume the operation: turn off the vacuum system by pressing the push-button (44),
then open the cover (34) and check that the float inside the grid (31) has gone down to the water level. Then
close the cover (34) and turn on the vacuum system by pressing the push-button (44).
When the recovery tank (33) is full, empty it according to the following procedure.
Recovery tank emptying
1. Lift the brush deck by pressing the pedal (10-A).
2. Lift the squeegee (29) with the lever (7).
3. Drive the machine to the appointed disposal area.
4.
Turn off the machine by pressing the main push-button (42) for 2 seconds, and (if equipped) turn the ignition key (41) to “0”.
5. Empty the recovery tank (33) with the drain hose (12). Then, rinse the tank with clean water.
Solution tank emptying
6. Perform steps 1 to 4.
7. Empty the detergent solution tank (21) using the level hose (13). Then, rinse the tank with clean water.
AFTER USING THE MACHINE
After working, before leaving the machine:
1. Remove the brush as shown in the relevant paragraph.
2. Remove the ignition key (41).
3. Empty the tanks (33) and (21) as shown in the relevant paragraphs.
4. Perform the daily maintenance procedures (see the Maintenance chapter).
5. Store the machine in a clean and dry place, with the brush and the squeegee lifted or removed.
6. Make sure that the machine cannot move independently.
MACHINE LONG INACTIVITY
If the machine is not going to be used for more than 30 days, proceed as follows:
1. Perform the procedures shown in After Using the Machine paragraph.
2. For versions with Detergent System, empty the detergent tank (17) and clean the system (see the procedure in Maintenance
chapter).
3. Close the solution tank valve (28-B).
4. Disconnect the battery connector (8).
9100002290(A)09-2017.indb 17
24/10/2017 14:24:04
