A-14 / ENGLISH
A-14
- FORM NO. 56041743 - BR755, BR855
AFTER USE
1 When
fi
nished scrubbing, press the Scrub ON/OFF Switch
(H)
, this will automatically raise, retract and stop all the machine systems (brush, squeegee,
vacuum, solution and detergent (EcoFlex models)). Then drive the machine to a service area for daily maintenance and review of other needed service up
keep.
2
To empty the solution tank, remove the Solution Drain Hose
(2)
from its storage clamp. Direct the hose to a designated “DISPOSAL SITE” and remove the
plug. Rinse the tank with clean water.
3
To empty the recovery tank, pull the Recovery Tank Drain Hose
(31)
from its storage area. Direct the hose to a designated “DISPOSAL SITE” and unscrew
the plug (hold the end of the hose above the water level in the tank to avoid sudden, uncontrolled
fl
ow of waste water). Rinse the tank with clean water.
4
Remove the brushes or pad holders. Rinse the brushes or pads in warm water and hang up to dry.
5
Remove the squeegee and rinse it with warm water. Open the Recovery tank cover and hang the squeegee from the recovery tank using the Squeegee
Storage Hook
(30)
.
6
Remove the hopper on cylindrical systems and clean thoroughly. Remove from either side of the machine by removing the skirt and tilting the hopper up and
away from housing, then pull out.
7
Check the maintenance schedule below and perform any required maintenance before storage.
MAINTENANCE SCHEDULE
MAINTENANCE ITEM
Daily
Weekly
Monthly
Yearly
Charge Batteries
X
Check/Clean Tanks & Hoses
X
Check/Clean/Rotate the Brushes/Pads
X
Check/Clean the Squeegee
X
Check/Clean Vacuum Shut-Off Float
X
Check/Clean the vacuum motor foam
fi
lter(s)
X
Empty/Clean Strainer Basket in Recovery Tank
X
Clean Hopper on Cylindrical System
X
Check Each Battery Cell(s) Water Level
X
Inspect Scrub Housing Skirts
X
Inspect and clean Solution Filter
X
Clean Solution Trough on Cylindrical System
X
Purge Detergent System (EcoFlex models only)
X
Lubrication of Machine
X
* Check Carbon Brushes
X
* Have Nil
fi
sk check the vacuum motor carbon motor brushes once a year or after 300 operating hours. The brush and drive motor carbon brushes check every
500 hours or once a year.
NOTE:
Refer to the Service Manual for more detail on maintenance and service repairs.
8
Store the machine indoors in a clean dry place. Keep from freezing. Leave the tanks open to air them out.
9
Turn the Master Key Switch
(A)
OFF (O) and remove the key.
LUBRICATING THE MACHINE
Once a month, apply light machine oil to lubricate the:
• Steering
Chain
•
General Pivot Points For the Squeegee and Scrub Deck Linkage
•
Side Skirt Height Adjustment Knobs
•
Steering Wheel Shaft Universal joint
•
Front Roller Bumper
revised 6/10
ELECTROMAGNETIC BRAKE
See Figure 6.5.
The Drive / Steer Wheel Assembly
(4)
has a
built in electromagnetic brake that is engaged whenever the
Master Key Switch
(A)
is OFF or the FWD / REV Drive Pedal
(3)
is in the neutral position. This brake can be manually over
ridden if necessary by inserting a medium to large screwdriver
behind the Yoke
(AA)
as shown. This should only be done in the
event you need to push or pull the unit.
FIGURE 6.5
