23
After Use
1
Raise the brushes (or pads) and raise the squeegee. Move the machine to a service area.
2
Turn the Master Key Switch (11) OFF and remove the key.
3
To empty the solution tank, take the Solution Drain Hose (12) off its hanger. Direct the hose to a floor drain or bucket and remove the plug.
Rinse the tank with clean water. Inspect the solution hoses; replace if kinked or damaged.
4
To empty the recovery tank, take the Recovery Drain Hose (16) off its hanger. Direct the hose to a floor drain or bucket and remove the
plug. Rinse the tank with clean water. Inspect the recovery and vacuum hoses; replace if kinked or damaged.
5
Remove the brushes or pad holders. Rinse the brushes or pads with warm water and hang it up to dry. Allow buffing pads to dry completely
before using again.
6
Remove the squeegee, rinse it with warm water and hang it up to dry.
7
Check the maintenance schedule below and perform any required maintenance before storage.
Maintenance Schedule
Once a
Once a
Once a
Maintenance Item
Daily
Week
Month
Year
Clean and Inspect the Tanks and Hoses
X
Clean the Brushes/Pads
X
Clean the Squeegee
X
Charge the Batteries
X
Check Battery Water Level
X
Lubricate the Machine
X
*Service the Vacuum Motor
X
*Have Nilfisk check the carbon motor brushes once a year or after 300 operating hours.
8
Store the machine in a clean, dry place.
