FORM NO. 56041446 / DuraGloss
™
2000 - 6
INTRODUCTION
This manual will help you get the most from your Kent DuraGloss 2000. Read
it thoroughly before operating the machine.
This product is intended for commercial use only.
PARTS AND SERVICE
Call the DEALER named below for repair parts or service. Please specify the
Model and Serial number when discussing your machine.
(Dealer, affix service sticker here)
NAME PLATE
The Model Number and Serial Number of your machine are shown on the
Nameplate on the front of the motor and on top of the motor shroud under the
cover. This information is often needed when ordering repair parts for the
machine. Use the space below to note the Model Number and Serial Number of
your machine for future reference.
MODEL NUMBER
SERIAL NUMBER
UNCRATING
When the machine is delivered, carefully inspect the shipping carton and the
machine for damage. If damage is evident, save the shipping carton so that it can
be inspected. Contact the Kent Customer Service Department immediately to file
a freight damage claim.
PREPARING THE FLOOR
Before each use of this machine, the floor must be clean and completely dry.
Clean the floor with an automatic floor scrubber or a damp mop, using a solution
of water and neutral cleaner.
CAUTION!
This machine should be used only on floors that are coated with a floor finish
suitable for burnishing. Contact your local Kent Distributor for further information
on floor finishing products.
PREPARING THE MACHINE FOR USE
WARNING!
Moving parts - To reduce the risk of injury, unplug before servicing.
A - INSTALLING THE PAD
To install a pad, tip the machine back on it’s handle. Remove the Pad Retainer
“A” (in the center of the pad holder) by turning clockwise to loosen. Put the proper
size Pad “B” on the Pad Holder Hub “C”. Re-install the Pad Retainer “A” by
turning counter-clockwise to tighten.
B - KNOW YOUR MACHINE
1
Operator Handle Grips
2
Switch Lever Safety Lock Button
3
Switch Levers - Squeeze - ON / Release - OFF
4
Handle Release Latch
5
Power Cord
6
Operator Handle
7
Motor Brush Wear Indicator Light
OPERATION
1
Unwrap the Power Cord and plug it into a properly grounded outlet.
2
Unlatch the handle by pushing forward on the Handle Release Latch with
your foot. Continue to hold latch while pulling the handle back. It is normal
for the base of the machine to lift off of the floor slightly when the handle
is lowered. It will pull itself down against the floor as soon as the motor is
started.
3
Hold one of the Operator Hand Grips firmly, push the Safety Lock Button
and then compress the switch levers to start the motor. NOTE: When the
dual controlled switch levers are released, the machine shuts off imme-
diately.
4
Push the machine forward in a straight line, at a slow walking speed.
Overlap each pass about 1-3 inches (25-75 mm).
5
When using a polishing pad, check every 15 minutes to see if the pad is
loaded up with wax and dirt. If it is, turn the pad over to expose the clean
side, or install a clean pad.
AFTER USE
1
Lift the Handle until it locks in the upright position.
2
Unplug the Power Cord and wrap it around the Handle Release Latch and
the right Operator Handle Grip.
3
Check the skirt around the dust control housing. The skirt should be
replaced if it is worn out or torn.
4
Remove the pad from the machine. Clean the pad and hang it up to dry.
Allow buffing pads to dry completely before using again.
5
Wipe the entire machine with a clean, damp cloth.
6
Inspect the entire machine and all accessories for damage. Perform any
required maintenance or repairs before storage.
7
Store the machine in a clean, dry place with the Handle locked in the
upright position.
