FORM NO. 56043055 / HR 2800, HR 2800C / BR 700, BR 700C
- 27
SCRUB BRUSH SYSTEM (CYLINDRICAL)
FRONT
S
T
D
S
U
U
T
R
SCRUB BRUSH MOTOR REMOVAL
1
See Figure 5. Remove the Hairpin
(R)
and swing open the scrub deck skirt assembly and remove the Belt Guard
(S)
(4 screws).
2
Loosen the scrub brush belt tension hardware at the Belt Idler
(T)
using a 5/8-inch and 11/16-inch wrenches.
3
Disconnect the brush motor wiring at both the Pos. & Neg. terminal connectors and note the correct motor wiring connections (for
reinstallation). Next remove the (3) Screws
(U)
and lift the motor out from the frame opening at the end(s) of the scrub deck.
4
Reassemble in reverse order and tension the belt as shown in figure 3.
7.36"
(187 mm)
Length of
Assembled Rod
1-1/8" (29 mm)
1 to 1-1/8" (25-29 mm)
1-1/8" (29 mm)
FIGURE 3
FIGURE 4
FIGURE 5
revised 2/05
Summary of Contents for Hydro-Retriever 2800 BR700
Page 2: ......
