Nilfisk-Advance IVB 3-H, Operating Instructions Manual

12

english

IVB 3-H
IVB 5-H
IVB 7-H

7.2.3  Replacing filter element 

„H“ (IVB 3-H)

3.  Open the retaining clamps and 

remove the upper section of the 
cleaner from the dirt tank. Lay 
the upper section of the cleaner 
down with the filter element fac-
ing upwards.

4.  Using the enclosed tool (2), turn 

the filter holder (1) anticlockwise 
and remove it.

5. Place the protective filter bag 

over the filter element (3).

6.  Carefully remove the filter ele-

ment and close the protective 
filter bag with a knot.

7.  Clean the filter seal (4). Check it 

for damage and replace it if nec-
essary.

8.  Check the antistatic clamp (5) 

for damage and have it replaced 
by Nilfisk-Advance Service if 
necessary.

9.  Fit a new filter element.
10. Check that the float (6) works 

properly. When the filter holder 
is turned, the float inside must 
move about easily.

11. Using the enclosed tool, attach 

the filter holder and turn it clock-
wise to lock it.

12. Dispose of the used filter ele-

ment in accordance with legal 
regulations.

7.2.4 Replacing filter element 

„H“ (IVB 5-H/7-H)

During the following 
work, ensure that dust 
is not unnecessarily 
spread around. Wear a 

cleaner down with the filter ele-
ment facing upwards. Do not 
place the upper section of the 
cleaner on the guard (1) and do 
not damage the filter element.

2.  Unscrew the screw (2), open the 

bar handle and remove it.

3.  Remove the filter holder (3).
4. Place the protective filter bag 

over the filter element.

5.  Carefully remove the filter ele-

ment and close the protective 
filter bag with a knot.

6.  Clean the filter seal (4). Check it 

for damage and replace it if nec-
essary.

7.  Check the antistatic clamp (5) 

for damage and have it replaced 
by Nilfisk-Advance Service if 
necessary.

During the following work, 
ensure that dust is not 
unnecessarily spread 
around. Wear a P2 

breathing mask.

P2 breathing mask.
Never use the vacuum cleaner with-
out a filter.

1. Remove the upper section 

of cleaner from the dirt tank. 
Lay the upper section of the 

4

1

3
2

Never use the vacuum cleaner with-
out a filter.

1.  Clean the filter element (see 

4.5).

2.  Switch off the vacuum clean-

er and wait approx. 5 minutes 
so that the dust can settle in 
the tank.

1

2

3

6

5

4