Nilfisk-Advance MICROMATIC 13E, Service Manual

GENERAL INFORMATION

ENGLISH

SERVICE MANUAL

4

9097511000(1)2008-04

Micromatic

TM

 13E

WARNING!

In case of fire, use a powder fire extinguisher, not a water one.

–

Do not tamper with the machine safety guards and follow the ordinary maintenance instructions 

–

scrupulously.

Do not allow any object to enter into the openings. Do not use the machine if the openings are clogged. 

–

Always keep the openings free from dust, hairs and any other foreign material which could reduce the air 

flow.

Do not remove or modify the plates affixed to the machine.

–

This machine cannot be used on roads or public streets.

–

Pay attention during machine transportation when temperature is below freezing point. The water in the 

–

recovery tank or in the hoses could freeze and seriously damage the machine.

Use brushes and pads supplied with the machine and those specified in the User Manual. Using other 

–

brushes or pads could reduce safety.

In case of machine malfunctions ensure that these are not caused by a lack of maintenance. Otherwise, 

–

request assistance from the authorised personnel or from an authorised Service Center.

If the machine

–

does not work properly

• 

is damaged

• 

has water or foam leaks

• 

has been left outdoors exposed to bad weather conditions

• 

is wet or has been dropped into water turn it off immediately and contact the Nilfisk Service Center or a 

• 

qualified technician.

If parts must be replaced, require ORIGINAL spare parts from an Authorised Dealer or Retailer.

–

To ensure machine proper and safe operation, the scheduled maintenance shown in the relevant chapter of 

–

this Manual, must be performed by the authorised personnel or by an authorised Service Center.

Carefully read all the instructions before performing any maintenance/repair procedure.

–

Do not wash the machine with direct or pressurised water jets, or with corrosive substances.

–

The machine must be disposed of properly, because of the presence of toxic-harmful materials (electronic 

–

components, etc.), which are subject to standards that require disposal in special centres (see the Scrapping 

chapter).