6
1 Operation:
•
Attach a garden hose to the auto-fi ll valve, and connect the other end of the hose to your water source.
• Make sure the fl oat that hangs from the auto-fi ll valve into the tank is free of obstruction and can
move
freely.
• Turn the water supply on. NOTE: high pressure is not necessary.
• The auto-fi ll fl oat will automatically shut-off the fl ow of incoming water when the solution tank is nearly
full, and it will allow the valve to open again once the water level has dropped to a predetermined level.
AUTO-FILL
1 Operation:
• Before each use: if necessary, unscrew the stainless steel fi lter at the bottom of the recovery
tank and clean it. Also make sure the fl oat in the recovery tank is clean.
•
Attach a garden hose to the dump pump outlet fi tting on the front of the base of the machine.
•
Run the other end of the hose into a drain.
•
Turn ON the dump pump switch (switch is located on the switch panel on the top of the machine).
• NOTE: the dump pump is ‘self-priming.’ You should see water start to fl ow within 30 seconds of
the pump turning on. If water does not begin to fl ow, check the fi lter to see if it is plugged with debris.
• After each job: run clear water though the dump pump to wash out any chemical residue.
Remove and clean the stainless steel fi lter in the back of the tank. Reinstall the fi lter once it is clean.
Clean and empty the recovery tank.
AUTO-DUMP
DANGER: DO NOT USE SOLVENTS, OR ANY CHEMICALS THAT MAY BE
FLAMMABLE, EXPLOSIVE, OR COMBUSTIBLE.
CAUTION: always use a defoamer in the recovery tank to prevent water or
foam from entering the vacuum motor.
CAUTION
: Use care when handling hazardous chemicals.
CAUTION:
Never put water hotter than 54 °C in the holding tank.
CAUTION
: Never leave the 1200 psi pump running when you are not actively
using
it.
AUTO VACUUM SHUTOFF:
When the recovery tank is full, the ball fl oat will shut-off the suction to prevent the machine from
overfl owing. NOTE: the fl oat may not work if there is foam in the tank. Always use defoamer to
prevent overfl ow
