9
TROUBLE SHOOTING:
IF THIS OCCURS
CHECK THIS
Solution tank is empty.
Clogged spray tip.
Pump not running or not primed.
Valve on wand not operating.
Debris is plugging cleaning tool or vacuum hose.
Drain hose is not completely closed. Vacuum tank lid is not closed or seal is
damaged.
No power to motor.
Test the switch.
Test the vacuum motor.
Spraying too long. Try spraying for 8 - 10 seconds, or about three strokes.
Heat exchanger needs to be fl ushed.
Wrong tool being used. Too much water passing through. Longer hose or larger
diameter hose, than standard.
Heat is not turned on.
No power in the wall outlet - check to see if the breaker has tripped.
No power to the heat switch - check wiring for ‘opens.”
No power out of heat switch, follow troubleshooting steps to isolate the problem.
Call your distributor for additional help.
NO HEAT
MAINTENANCE SCHEDULE
CLEAN ALL FILTERS
X
FLUSH OUT with DESCALER
X
DAIL
Y
WEEKL
Y
MONTHL
Y
OTHER
CHECK POWER CORD
REPLACE VAC MOTOR BRUSHES
YEARL
Y
X
Around 1500 hours
REPLACE PRESSURE REGULATOR
X
Or as needed
NO SPRAY
LOW SUCTION
NO SUCTION
LOW HEAT
REBUILD PUMP
Around 1500 hours
If you are unable to diagnose the problem, contact your distributor
