Wheels, Drive System 103
Service Manual – SC2000
Drive System Gearmotor Disassembly/Assembly
Warning! This procedure must be performed by qualified personnel only and with the help of
an assistant.
1.
Drive the machine on a level floor or on a hoisting system to facilitate the disassembly procedures.
2.
Place a suitable lifting device (A, Figure 5) to raise one side of the machine approximately 2 cm from the
floor.
3. Remove the plug (B), remove the screw (C) and retrieve the washer.
4. Remove the wheel (D) and retrieve the key.
5. Disconnect the connection (E).
6. Remove the 4 screws (F) and retrieve the washer.
7. Repeat step 2 to 6 for the other wheel, then carefully disassemble the gearmotor (G) from the machine.
Figure 5
C
E
A
B
D
G
F
F
F
F