6 - FORM NO. 56041486 / SD 17 / 20
INTRODUCTION
This manual will help you get the most from your Nilfisk-Advance SD 17/20.
Read it thoroughly before operating the machine.
This product is intended for commercial use; polishing, spray buffing, scrub-
bing, stripping and rotary carpet shampooing.
PARTS AND SERVICE
Repairs, when required, should be performed by your Authorized Nilfisk-
Advance Service Center, who employs factory trained service personnel, and
maintains an inventory of Nilfisk-Advance original replacement parts and
accessories.
Call the NILFISK-ADVANCE DEALER named below for repair parts or service.
Please specify the Model and Serial Number when discussing your machine.
(Dealer, affix service sticker here.)
NAME PLATE
The Model Number and Serial Number of your machine are shown on the
Nameplate on the bottom of the machine. This information is needed when
ordering repair parts for the machine. Use the space below to note the Model
Number and Serial Number of your machine for future reference.
MODEL NUMBER
SERIAL NUMBER
UNCRATE THE MACHINE
When the machine is delivered, carefully inspect the shipping carton and the
machine for damage. If damage is evident, save the shipping carton so that
it can be inspected. Contact the Nilfisk-Advance Customer Service Depart-
ment immediately to file a freight damage claim.
(A)-KNOW YOUR MACHINE
1
Operator Handle Grips
2
Switch Lever Safety Lock Button
3
Switch Levers - Squeeze - ON / Release - OFF
4
“Kwik Lok” Handle Adjustment Lever
5
Power Cord
6
Operator Handle
WARNING!
This machine contains moving parts. To reduce the risk of injury,
always unplug the power cord before servicing.
(B)-INSTALLING THE BRUSH OR PAD
HOLDER
Align the Lugs (A) with the corresponding Slots (B) in the brush or pad holder
and turn the brush or pad holder counterclockwise to lock it in place. To remove
brush/pad holder, give it a quick, hard turn clockwise.
CAUTION!
Using the wrong brush or pad on this machine can damage the
floor or overload the motor.
OPERATION
1
Unwrap the Power Cord and plug it into a properly grounded outlet.
2
Loosen the foot operated “Kwik Lok” lever with the toe of your foot by
pulling up on the bottom of the lever. Move the Operator Handle
downward until your arms are almost straight. Then step down on top
of the lever to lock it.
3
Lift the Handle until the brush (or pad) is flat against the floor.
WARNING!
Be prepared to control the machine as soon as the motor starts.
Just a slight up or down movement of the Handle will make the
machine move from side to side. Raise the Handle to go right.
Lower the Handle to go left.
CAUTION!
Immediately start moving the machine back and forth. Keep the
machine moving while the motor is running to avoid damage to
the floor or carpet.
4
Hold one of the Operator Hand Grips firmly, push the Safety Lock
Button and then compress the switch levers to start the motor. NOTE:
When the dual controlled switch levers are released, the machine shuts
off immediately.
NOTE: When spray buffing, check the pad every 15 minutes for dirt and
wax build-up. If the pad is dirty, turn it over to expose the clean side or
install a clean pad.
