10 - FORM NO. 56041454 / SELECTGLOSS 20B
____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
BATTERY MAINTENANCE AND CHARGING
Charge the batteries each time the machine is used for 1 hour or longer, or whenever the Battery Meter reads in the red area.
To Charge the Batteries...
1
Remove the cover shroud and pull the gray battery connectors apart.
2
Push the connector from the charger into the connector from the batteries.
3
Follow the instructions on the battery charger.
4
Check the fluid level in all battery cells after charging the batteries. Add distilled water, if necessary, to bring the fluid level up to the bottom of the filler tubes.
CAUTION!
To avoid damage to floor surfaces, wipe water and acid from the top of the batteries after charging.
CAUTION!
Acid can spill onto the floor if the batteries are overfilled.
____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
LUBRICATION
Lubricate all pivot points of the pad raise/lower assembly with a dry film silicone lubricant.
Grease the fittings on the front casters and on the rear wheels once a month.
_____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
PAD MOTOR BRUSHES
A Red Light (4) on the control panel indicates when the carbon brushes in the pad drive motor need to be replaced. When this light glows, STOP USING THE MACHINE
and contact your local Kent distributor to have the brushes serviced.
CAUTION!
The pad drive motor can be damaged beyond repair if the machine is used with the red light glowing.
IMPORTANT!
Motor damage resulting from failure to service carbon brushes is not covered under warranty. See the Limited Warranty statement.
____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
TROUBLESHOOTING
____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
MACHINE VIBRATION
1
Pad is not centered properly. Remove the pad and reinstall.
2
Defective pad. Replace.
____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
SWIRL MARKS
1
Pad is too aggressive for the floor finish.
2
Pad is dirty. Check and replace.
____________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
REDUCED RUNNING TIME
1
Pad pressure too high. Check the Pressure Meter (5) adjust the Pad Pressure Lever (11) so the Pressure Meter stays in the green area most of the time.
2
Batteries need to be charged.
3
Batteries need water. Add just enough to cover the plates in each cell. Then charge the batteries and check the water level again.
MAINTENANCE / TROUBLESHOOTING
