USER MANUAL
ENGLISH
SR 1300H P
146 1064 000(3)2007-02 A
17
AFTER MACHINE USE
After working, before leaving the machine:
Turn off the vacuum system with the lever (75) and press the fi lter shaker switch (66) for a short interval, then turn on the
vacuum system again.
Empty the hopper (4) (see the procedure in the previous paragraph).
Lift the main broom with the lever (82).
Lift the side brooms with the levers (79) and (80).
Turn the engine throttle lever (77) to MIN (idle speed).
Turn off the machine by turning the ignition key (69) to "0", then remove it.
Engage the parking brake by pressing the pedal (84), then engage the brake lock control lever (76).
PUSHING/TOWING THE MACHINE
To easily push/tow the machine when it is off, proceed as follows:
Turn off the machine by turning the ignition key (69) to "0".
Open the hood (23) and secure it with the support rod (55).
Remove the screw (37).
Disengage the support rod (55) and close the hood (23).
Push or tow the machine.
After pushing/towing the machine, install the screw (37).
WORKING LIGHT ADJUSTMENT
If necessary, adjust the working light beam aiming (9) with the screws (21).
MACHINE LONG INACTIVITY
If the machine is not going to be used for more than 30 days, proceed as follows:
Check that the machine storage area is dry and clean.
Disconnect the negative connector (-) of the batteries (24).
Handle the engine (29) as shown in the relevant Manual.
FIRST PERIOD OF USE
After the fi rst 5 hours perform the following procedures:
Check the fastening and connecting parts for proper tightening; check the visible parts for integrity and leakages.
Change the engine oil (see the procedure in Maintenance chapter).
1.
•
•
•
•
•
•
•
–
–
–
–
–
–
1.
2.
3.
1.
2.
