ENGLISH
USER MANUAL
4
SCRUBTEC 234 C - 9099346000
SYMBOLS THAT APPEAR ON THIS MANUAL
DANGER!
It indicates a dangerous situation with risk of death for the operator.
WARNING!
It indicates a potential risk of injury for people.
CAUTION!
It indicates a caution or a remark related to important or useful functions.
Pay careful attention to the paragraphs marked by this symbol.
NOTE
It indicates a remark related to important or useful functions.
CONSULTATION
It indicates the necessity to refer to the User Manual before performing any procedure.
GENERAL INSTRUCTIONS
Specifi c warnings and cautions to inform about potential damages to people and machine are shown below.
DANGER!
–
Before performing any maintenance, repair, cleaning or replacement procedure disconnect the plug from
the electrical mains.
–
This machine must be used by properly trained operators only.
–
Do not wear jewels when working near electrical components.
–
Do not work under the lifted machine without supporting it with safety stands.
–
Do not operate the machine near toxic, dangerous, fl ammable and/or explosive powders, liquids or
vapours: This machine is not suitable for collecting dangerous powders.
WARNING!
–
Before using the machine, close all doors and/or covers as shown in the User Manual.
–
Do not tamper with the power supply cable plug. If the power supply cable plug cannot be connected to the
outlet, have appropriate outlet installed by a qualifi ed technician, according to the law in force.
–
Before connecting the power supply cable to the electrical mains, check that frequency and voltage, shown
on the machine serial number plate (1), match the electrical mains voltage.
–
Do not unplug the machine by pulling the supply cable. To unplug, grasp the plug, not the cable.
–
Do not handle the plug or the machine with wet hands.
–
Turn off all controls before unplugging.
–
Regularly check the power supply cable for damages, cuts, cracks and wear. If necessary, replace it.
–
If the power supply cable is damaged, contact Nilfi sk Alto Service Center.
–
Do not pull or carry the machine by the power supply cable and never use the power supply cable as a
handle. Do not close a door on the power supply cable, or pull the power supply cable around sharp edges
or corners. Do not run the machine on the power supply cable.
–
The brush must not come into contact with the power supply cable.
–
Keep the supply cable away from heated surfaces.
–
To reduce the risk of fi re, electric shock, or injury, do not leave the machine unattended when it is plugged
in. Disconnect the machine from the electrical mains when not in use and before performing maintenance
procedures.
