909 6313 000(2)2007-06 A
SCRUBTEC 343B
15
USER MANUAL
ENGLISH
TANK EMPTYING
An automatic fl oat shut-off system (44) turns off the vacuum system when the recovery water tank (31) is full.
The vacuum system shutdown, due to the recovery water tank fi lling, is signalled by an increase in the vacuum system motor noise,
moreover the fl oor is not dried.
CAUTION!
If the vacuum system turns off accidentally (for example, when the fl oat is activated because of a sudden
machine movement), to resume the operation: turn off the vacuum system by pressing the switch (66), then
open the cover (6) and check that the fl oat inside the grid (46) has gone down to the water level. Then close
the cover (6) and turn on the vacuum system by pressing the switch (66).
When the recovery water tank (31) is full, empty it according to the following procedure.
Recovery water tank emptying
Start the machine by pressing the brush/pad-holder and vacuum system switches (65 and 66).
Lift the squeegee with the lever (19).
Push the machine to the appointed disposal area.
Insert the positioning pin (24) and lift the brush/pad-holder by engaging the transport/parking device (23a).
Empty the recovery water tank with the drain hose (16). Then, rinse the tank with clean water.
Solution tank emptying
Perform steps 1 to 4.
Empty the solution tank by using the drain valve (18). Then, rinse the tank with clean water.
AFTER USING THE MACHINE
After working, before leaving the machine:
Remove the brush/pad-holder as follows:
With the brush/pad-holder lifted, turn the brush/pad-holder switch (65) to “I” and, after a few seconds, back to “0”, thus
releasing the brush/pad-holder.
Empty the tanks (31 and 32) according to the procedure shown in the previous paragraph.
Perform the daily maintenance procedures (see the Maintenance chapter).
Store the machine in a clean and dry place, with the brush/pad-holder and the squeegee lifted or removed.
1.
2.
3.
4.
5.
6.
7.
1.
•
2.
3.
4.
RECOVERY WATER TANK REMOVAL
To check or charge the lead (WET) batteries, or to perform other
procedures, it may be necessary to remove the recovery water
tank (31) as shown below.
Empty the recovery water tank (31) as shown in the
relevant paragraph.
Drive the machine on a level fl oor.
Make sure that the switches (65 and 66) are in the "0"
position.
Disconnect the vacuum hose (22) from the squeegee (11).
Disconnect the recovery water drain hose (16) from the
bracket (17).
Open the cover (6).
Grasp the recovery water tank (A, Fig. 5) in the area (B)
and slightly raise it.
Disconnect the vacuum hose (C) from the tank, then
remove the tank (A) with the hoses (D) and (E).
1.
2.
3.
4.
5.
6.
7.
8.
A
C
B
D
E
Figure 5
S310233 A
Summary of Contents for SCRUBTEC 343B
Page 2: ......
