Scrub System, BOOST
®
101
Service Manual – SCRUBTEC R466 ... FOCUS II Micro Rider
BOOST
®
deck vibration-dampers disassembly/replacement
1 remove the BOOST
®
deck from the machine
2
At the workbench, remove the screw (A), recover
the washer and remove the locking eccentric disc
(B)
3
Remove the screws (C), recover the washers and
lift the motor holder assembly (D)
4 Recover the spacer (E) and the key (F)
5
Remove the nuts (G), lift the deck holder
assembly (H) and recover the washers.
6 Remove the vibration-dampers (I) from the pad
holder stays (J).
7 Assemble the new vibration-dampers in the
reverse order of disassembly, and note the
following:
◦
Add Loctite on the lower thread and manu-
ally install the vibration-dampers (I) on the
pad holder stays (J).
◦
Apply Loctite on the top thread of the vibra-
tion-dampers (I)
◦ Tighten the nuts (G) at 8.8 lbf/ft (12 N/m,
1.22 kgf/m).
◦ When tightening the screws (C) and (A), ap
-
ply Loctite on threads
◦ When tightening the screw (A), use an impact
driver
C
G
G
D
G
C
C
E
H
F
B
G
G
I
I
I
I
J
G
A
P100741
