Scrub System, BOOST
®
104
Service Manual – SCRUBTEC R466 ... FOCUS II Micro Rider
BOOST
®
Deck Adjuster Spring Disassembly/Assembly
Disassembly
1
Drive the machine on a level floor.
2 Remove the BOOST® deck
3 Turn the ignition key to “0” and disconnect the batteries
4
Remove the front fairing (see the procedure in “Front Fairing Disassembly/Assembly” paragraph,
Steering System section)
5 Place a wooden shim (A) under the deck holder assembly Wooden shim thickness must be 160 mm
6
Unscrew the ring nut (B), recover the washer, then carefully remove the spring (C).
7
If necessary, replace the spring taking care to properly place the elastic ends (D) on the frame.
Assembly
8
Assemble the components in the reverse order of disassembly, and note the following:
◦
Tighten the ring nut (B) so that the deck holder assembly can turn freely
A
B
C
D
P100734
