ENGLISH
USER MANUAL
4
909 6752 000(3)2010-03 A
BA 551 - BA 551D - BA 551CD - BA 611D
SAFETY
The following symbols indicate potentially dangerous situations. Always read this information carefully and take all necessary
precautions to safeguard people and property.
The operator’s cooperation is essential in order to prevent injury. No accident prevention program is effective without the total
cooperation of the person responsible for the machine operation. Most of the accidents that may occur in a factory, while working
or moving around, are caused by failure to comply with the simplest rules for exercising prudence. A careful and prudent operator is
the best guarantee against accidents and is essential for successful completion of any prevention program.
SYMBOLS
DANGER!
It indicates a dangerous situation with risk of death for the operator.
WARNING!
It indicates a potential risk of injury for people or damage to objects.
CAUTION!
It indicates a caution or a remark related to important or useful functions. Pay careful attention to the
paragraphs marked by this symbol.
NOTE
It indicates a remark related to important or useful functions.
CONSULTATION
It indicates the necessity to refer to the User Manual before performing any procedure.
GENERAL INSTRUCTIONS
Speci
fi
c warnings and cautions to inform about potential damages to people and machine are shown below.
DANGER!
Before performing any maintenance, repair, cleaning or replacement procedure disconnect the battery
–
connector and remove the ignition key.
This machine must be used by properly trained operators only. Children or disabled people cannot use this
–
machine.
Keep the battery away from sparks,
fl
ames and incandescent material. During the normal operation explosive
–
gases are released.
Do not wear jewels when working near electrical components.
–
Do not work under the lifted machine without supporting it with safety stands.
–
Do not operate the machine near toxic, dangerous,
fl
ammable and/or explosive powders, liquids or vapours:
–
This machine is not suitable for collecting dangerous powders.
Battery charging produces highly explosive hydrogen gas. Keep the tank assembly open during battery
–
charging and perform this procedure in well-ventilated areas and away from naked
fl
ames.
WARNING!
Carefully read all the instructions before performing any maintenance/repair procedure.
–
Before using the battery charger, ensure that frequency and voltage values, indicated on the machine serial
–
number plate, match the electrical mains voltage.
Do not pull or carry the machine by the battery charger cable and never use the battery charger cable as
–
a handle. Do not close a door on the battery charger cable, or pull the battery charger cable around sharp
edges or corners. Do not run the machine on the battery charger cable.
Keep the battery charger cable away from heated surfaces.
–
Do not use the machine if the battery charger cable or plug is damaged. If the machine is not working as it
–
should, has been damaged, left outdoors or dropped into water, return it to the Service Center.
909 6752 000(3)2010-03 A.indb 4
909 6752 000(3)2010-03 A.indb 4
04/03/2010 15.01.19
04/03/2010 15.01.19