RHL75xx.A.2.10.151600.201604151852.x7160_1_signed.exe
You will see something similar to the following screen:
Initial Screen
Plug your modem into the Skywire Development Kit, plug the USB cable into Port J5,
plug in the power cable, and plug the USB cable into your workstation. Press the
ON_BTN, and the upgrade process should start. If it does not, remove power, reapply
power, and press the ON_BTN again.
The firmware upgrade process should take less than 10 seconds over USB 2.0. During
the process, you will see a screen similar to:
Firmware Upgrade Progress
Once your firmware upgrade is complete, you will see a screen similar to the following:
PN 30270 rev 5
© NimbeLink Corp. 2018. All rights reserved.
10
