rev. 20.2
Overview / Getting Started
5
Charging:
Before first using your XLR8, please plug in and fully charge your
XLR8. Blinking green battery power indicator lights on your device and a red
light on the plug indicate that your device is charging.
When charging is complete, your device power indicator will show steady
green lights up to the 100% mark and your plug will show a steady green light.
The battery charge indicator will light when your XLR8 needs to be recharged.
With an average daily use of 30 minutes, your XLR8 battery charge should last
for 7-10 days. Charging time for a fully drained battery is typically 3-4 hours.
PLEASE DO NOT ATTEMPT TO USE WHILE CHARGING.
Turn On XLR8:
Press the power button to turn on the device
—
the speed
indicator lights will show the starting (lowest) speed of 20Hz.
Turn Off XLR8:
To turn off the devices, press the power button again and all
light indicators (battery power, speed) will go out
Percussion Speed Controls:
Your XLR8 enables you to increase and decrrease
percussion speeds to six different settings. To increase the speed, press the +
button and to decrease the speed press the – button.
Cleaning
• DO NOT SUBMERGE YOUR XLR8 IN ANY FLUID
• DO NOT GET THE UPPER PORTION OF THE XLR8 WET
• DO NOT USE ANY CHEMICAL CLEANERS ON YOUR XLR8
• XLR8 handle and gun: wipe down with light soap and damp cloth
• Thumb, Plate, Y, Point, Apollo: general use cleaning wipes or soap and water
• Ball: water only
• Make sure attachment heads are fully dry before inserting them into the
XLR8 gun
• Be careful not to puncture attachment heads
General Care
• Do not use any attachments other than the ones included with your NIMBL
XRL8, and use only as instructed by NIMBL
• Do not run the battery all the way to empty
• Store in a cool dry place
• Do not use for longer than 15 continual minutes in one session to avoid
damage to the motor
