6
42445 Avenida Alvarado, Temecula, CA 92590
(800) 451-9343, www.nimbuswater.com
CS-2 Push Handle Faucet
For easier installa
ti
on, a
tt
ach all tubing prior to moun
ti
ng the
faucet.
1. Insert polished faucet base onto base of faucet.
2. Push the 1/4” drain tubing onto the 1/4” barb
fi
tti
ng. This tube
must be of su
ffi
cient length to reach the white swivel with yellow
collet on the membrane desalinator.
3. Push the 3/8” tubing onto the larger 3/8” barbed
fi
tti
ng, being
sure you have enough tubing to reach the drain saddle.
4. Slip the 1/4" and 3/8" tubing though opening in polished faucet
base. Slide white plas
ti
c spacer open-end-up onto the threaded
faucet stem (2).
5. Thread the 3/8" washer (3) and moun
ti
ng lock nut (4) onto the
threaded stem. (Fig 6)
6. Thread faucet quick-connect adapter (5) on to threads of faucet
stem. NOTE: This connec
ti
on should be hand-
ti
ghtened only. Push
one end of product tubing into connec
ti
on.
7. Insert tubing and faucet assembly down through the sink hole.
8. Posi
ti
on the faucet to the desired handle orienta
ti
on. Slip the
slo
tt
ed washer (1) between the white plas
ti
c spacer and the sink.
Securely hand
ti
ghten the moun
ti
ng nut.
9. Connect the 3/8” tubing to the drain saddle assembly using the
drain connector nut supplied. This tubing should follow as direct a
path as possible; long runs, looping or deep sags will restrict nor-
mal brine
fl
ow to the drain. Save the unused por
ti
on of the tubing
for the installa
ti
on of the storage tank.
10. Apply a small amount of silicone-based lubricant to the O-rings
located at the base of the spout. Firmly insert spout assembly into
the top hole of faucet body (approximately 1/4"). You may swivel
the faucet le
ft
or right.
Airgap to system drain
(1/4" tubing)
Faucet to drain
saddle (3/8" tubing)
Product water
(1/4" tubing)
Metal base plate
Rubber seal
1
2
3
4
5
Connect to product
water tubing
