WiMi300A User Manual v.1.4
©
2016 NIMBUS INC. All rights reserved.
4/10
www.nimbus.kr
between the radiator & your body.
•
This device is intended only for OEM integrators under the following conditions:
The antenna must be installed such that 20 cm is maintained between the antenna and users,
and The transmitter module may not be co-located with any other transmitter or antenna. As
long as 2 conditions above are met, further transmitter test will not be required. However, the
OEM integrator is still responsible for testing their end-product for any additional compliance
requirements required with this module installed.
•
IMPORTANT NOTE:
In the event that these conditions cannot be met (for example certain laptop configurations
or colocation with another transmitter), then the FCC authorization is no longer considered
valid and the FCC ID cannot be used on the final product. In these circumstances, the OEM
integrator will be responsible for re-evaluating the end product (including the transmitter) and
obtaining a separate FCC authorization.
•
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be
installed such that 20 cm may be maintained between the antenna and users. The final end
product must be labeled in a visible area with the following:
“Contains FCC ID: ZD7-WIMI300A”.
The grantee's FCC ID can be used only when all FCC compliance requirements are met.
•
Manual Information To the End User
The OEM integrator has to be aware not to provide information to the end user regarding
how toinstall or remove this RF module in the user's manual of the end product which
integrates this module. The end user manual shall include all required regulatory
information/warning as show in this manual.
