4
KSPMNL/00/12.04.2019
4.
Preparing the Product for the Use
1.
Install the unidirectional milk valve in the location below the pump housing.
Make sure that it is seated in place by pushing it as far as possible.
2.
Fit the pump body by turning it clockwise until the bo
tt
le is seated well.
3.
Install the suction level adjuster part in the silicone suction diaphragm. Make
sure it is seated properly.
4.
Install the combined silicone suction diaphragm and suction level adjuster on
the upper side of the pump body. Make sure that the frame is fully engaged
by pressing it down.
5.
Pass the head of the suction level adjuster part that we have already
assembled from the notch above the handle. While in this position, push the
lever down until it clicks into place on the pump body.
6.
Place the silicone breast pad into the breast funnel on the pump body. Push it
forward until you are sure it is fully seated. Ensure that the breast pad part is
seated so that the funnel part of the pump body is wrapped from the outside.