3
C. Set up by Auto Search
This search is similar to Manuel Search except it transmits power signal
automatically instead of manually pressing the power key during the search:
1. Power on the device you want to control.
2. Press and hold
[SET]
key, in the meantime, press and hold the Device key that
you want to control (for example:
TV
) for more than
3 seconds
and then
release
them, the auto search begins. The remote control enters into Auto
Search, LED flash, and remote control transmit power signal every 2.0 second
automatically.
3. See if device react or not, once the device reacts, press any key (except SET
key) to
stop
the search.
4.
Test
if other keys work well enough. If most keys don’t work well enough,
Auto Search again to find next reactive code and try until you find the best
code.
Remark:
a.
You must point your remote control to the device that you want to control
during Auto Search.
b.
Whenever you want to leave Auto Search mode, press any key (except SET key)
to quit, and the LED will be Off. The search is over.
c.
When remote control search through all codes (about 10 minutes), then the
remote control will quit from Auto Search process automatically.
d.
In case of you did not stop the search on time when device reacted, you may
use the Manual Search to search back to find the overlooked code.
Device Lock/Unlock
You can use “Device Lock” function to fix current device code and this device code
cannot be changed by code set up or code search. You can use the “Unlock” to quit
from this function.
a. Strike the device key that you want to fix such as
[TV]
, [DVD]
b. Press and hold the
[SET]
key, then press the
[7]
key, then release the both pressed
keys, the LED will blink twice then off, the code of the current device are locked.