Set up the Primar y and
Advanced Control Switch
We have set up the primary and advanced control model to meet
the different fans requirement.
1
.
Turn on the transmitter, check the present model of transmitter. if
the mode is advanced the illustration as left, if the mode is primary
the illustration as right.
Advanced
mode
Primary
mode
2
.
Press the button to switch the mode of the primary and advanced.
Note: This throttle curve in the low rate mode is also different
than it is in the high rate mode. This makes it much smoother
and easier to control the throttle when in the low rate mode.
The advanced mode is suitable for the experienced pilot .We
suggest you choose the primary mode when you first flight the
helicopter.
Transmitter Mode Switch Function
In order to meet the different customer requirement, we use the
transmitter with the mode switch function .it can switch between the
lift and right hand
.
Please go ahead the following process to switch the mode from
Mode2 to Mode1
:
1
.
Turn off the transmitter
.
1
www
.
NineEagle
.
com
1
www
.
NineEagle
.
com
15
www
.
NineEagle
.
com
2
.
Take off the fixed nut on the antenna
and clip.
3
.
Reverse the antenna 90 degree ,
circumrotate the antenna shaft 180
degree,then make the antenna to cling
another side of transmitter .
4
.
Re-install the nut and the fix clip on
the antenna.
5
.
Turn on the transmitter then be the mode1 operation
.
Control
Test
Although the FREE SPIRIT MICRO and SOLO are test flown at the
factory,
we still suggest you inspect the productive quality when you
open the box to ensure none of the any parts were damaged during
shipping and handling .
1
.
Turn on
the transmitter.
2
.
Slide the li-po into the slot of helicopter ( usually the copper
spring facing inward),
to prevent reverse polarity connection
.however ,please be sure to check for proper alignment and polarity
before proceeding to the next step
.
16
www
.
NineEagle
.
com
