Quitting calibration mode
Press the left-hand transmitter stick on-
ce. When you hear a further beep, you
have left the mode, and can fly the mo-
del.
Note:
If calibration mode does not immediately start correctly, repeat
the procedure until the Status LED flashes. Please be careful not
to hold the right-hand stick pressed in for too long, otherwise you
will enter Dual Rate set-up mode.
20
Calibrating the acceleration sensor
The acceleration sensor can be adjusted at the model's receiver.
Normally the machine is calibrated correctly at the factory, and
is immediately ready to fly. If you notice inconsistencies in the
model's behaviour in flight, you can re-calibrate the acceleration
sensor and thereby improve its flying characteristics.
Entering calibration mode
First switch the transmitter on, then
place the model in a horizontal position
and connect the flight battery. Hold the
right-hand transmitter stick pressed in,
then press the left-hand stick three times
in sequence. You will hear a beep which
indicates that you are in Calibration mo-
de. Release the right-hand stick again.
Calibration
Move the throttle trim on the transmitter
upward. The Status LED now flashes
slowly, and the acceleration sensor is in
calibration mode. Now switch the trans-
mitter off and immediately on again. The
procedure is complete when the Status
LED glows constantly.
Operating Instructions - GALAXY VISITOR 3 RTF FTR 2.4 GHz No. NE2529M2
No. NE2529M1
Mode 2
