14
SG
+65 800 120 5111
MY
+60 1800 803 915
15
ninjakitchen.sg | ninjakitchen.my
7
Turn cup over so blade assembly
is on top� Rotate blade assembly
anti-clockwise to remove� To take
your blended contents on the go,
place the spout lid on cup and turn
clockwise to seal�
8
Unplug the unit when finished� To lift
the motor base, place your hands
underneath both sides of it and
gently pull the unit up and toward
you� Refer to the Care & Maintenance
section for storing instructions�
6
When blending is complete, lift
the cup up and out of the motor
base� Pressure must be released
before opening the cup (see step
14 below)�
DO NOT
store contents
in the cup with the Pro Extractor
Blades™ Assembly attached�
CARE & MAINTENANCE
CLEANING
1
Separate all parts�
2
Wash all containers in warm, soapy
water with a soft cloth�
3
Hand-Washing
Wash cups, lids, blade assembly, and
overflow reservoir in warm, soapy
water� Use a dishwashing utensil
with handle to avoid direct contact
with the blades� Exercise care when
handling the blade assembly as the
blades are sharp� Thoroughly rinse
and air-dry all parts�
TIP:
If you find residue underneath
the FreshVac™ Tab, try lifting it gently
and rinsing under warm water�
DO NOT
remove FreshVac Tab�
Dishwasher
Cups, lids, and blade assembly are
dishwasher safe� Place the cups, lids,
and blade assembly on the top rack
of the dishwasher
ONLY
� Ensure the
blade assembly and lid are removed
from the cup before placing in the
dishwasher� Make sure Flip & Seal Lid
on the cup is open before starting
cleaning cycle�
NOTE:
Overflow Reservoir is not
dishwasher safe�
Motor Base
Turn off the unit and unplug
the motor base before cleaning�
Wipe motor base with a clean,
damp cloth�
NEVER
directly spray the base
with water or other liquids�
DO NOT
use abrasive cloths/pads/
brushes to clean the base, as this
can dull or scratch the surface�
FRESHVAC™ PUMP
NEVER
submerge the pump in water
or other liquid� To clean pump, apply an
all-purpose cleaner to a soft cloth, such
as microfibre, and wipe gently�
NEVER
submerge the pump in water
or other liquid� If you see water or
other liquid in the overflow reservoir:
1
Remove overflow reservoir
from pump and wash and dry it
thoroughly�
2
Run pump for 10 seconds to clear
any fluid�
3
Wipe pump clean with a soft cloth�
4
Reattach overflow reservoir to
pump�
RESETTING THE MOTOR
THERMOSTAT
This unit features a unique safety
system that prevents damage to
the motor and drive system should
you inadvertently overload it� If the
unit is overloaded, the motor will be
temporarily disabled� Should this occur,
follow the reset procedure below�
1
Unplug the unit from the
electrical socket�
2
Allow the unit to cool for
approximately 30 minutes�
3
Remove the container’s lid and blade
assembly� Empty the container and
ensure no ingredients are jamming
the blade assemblies�
IMPORTANT:
Ensure that
maximum capacities are not
exceeded� This is the most typical
cause of appliance overload�
If your unit needs servicing,
please call Customer Service
on 0800 862 0453�
