109
7d
CYLINDER
Pipe
Hook wrench
221W095E
Put the cylinder horizontal. Remove the plug and the
gasket.
2.
Loosen the cylinder head.
Loosen the cylinder head by using a hook wrench, and
then remove the cylinder head from the cylinder tube
ASS'Y.
Since the remaining oil may be spilled, put an oil pan to
receive.
3.
Drain the oil.
1.
Disassembly procedure
4
4
If the plug is not removed before disassembling,
p i ston , p i ston seal, b u shing a nd /o r ot h e r
internal parts may be damaged.
CAUTION
Pull out the cylinder head.
Pull the cylinder head straightly with care.
4.
Pull out the piston rod ASS'Y.
Pull out the rod carefully with keeping horizontally.
Don't forget to remove the plug before pulling the rod out.
5.
Pull out the spacer.
Pull the spacer out from the piston rod ASS'Y.
If the wear ring is fit on the spacer, that spacer cannot be
removed from the rod. Only the spacer without wear ring
can be removed from the rod.
The wear ring itself can be removed by hand.
6.
Spacer
Wear ring
221W111E
When removing the cylinder head from the rod,
the end of the rod may hit and damage the head
if it is pulled out roughtly.
CAUTION
Be careful not to damage the rod when pulling
out from the outer tube especially around the
thread part at the end of the tube or if the rod is
long.
CAUTION
https://www.forkliftpdfmanuals.com/
