111
7d
CYLINDER
Jig
Bushing
Press down using a press.
Jig
Cylinder
head
221W099E
Disassembly of the bushing in the cylinder head (If
required).
Use a jig, as shown in the illustration on the right, and
push the bushing out by using a press.
Or, pull out the bushing by the following procedure.
1. Groove the inside face of the bushing by using a tool.
(Groove parallel about 10 mm away from the joint.)
2. Stick a flat head screwdriver into the joint of the
bushing, and twist along the groove to bend the edge
of the bushing.
3. Grab the bent part of the bushing with a plier and pull it
out.
9.
Cleaning and storage
1. Clean all removed parts with kerosene.
After wipnig kerosene off, apply the hydraulic oil on
them before storage.
2. If removed parts are left without cleaning, they may be
rusted or damaged by moisture or dust.
10.
Replace the bushing to the new one when
reassembling.
NOTE
https://www.forkliftpdfmanuals.com/
