170
ACCELERATOR
10c
10c-2-1. Potentiometer - adjustment
1. Adjust the fixing position of the potentiometer to get
the following output voltage.
(1) Apply DC 5 0.5 volts between Red (+) and Black (-).
(2) Measure the voltage between White (output 1) and
Black (-), and make sure if the voltage is within the
range.
(3) Measure the voltage between Blue (output 2) and
Black (-), and make sure if the voltage is within the
range.
(4) If you cannot get the correct output voltage, remove
the potentiometer once and turn the shaft 180 . Then
install and test again.
(5) If you cannot get the correct output voltage for both
output 1 (white) and output 2 (Blue), replace the
potentiometer to the new one.
Inspection and adjustment
10c- 2.
Lever position
Output voltage
Neutral
0.85 ± 0.1 V
51.5 degree rotated
3.5 V - 4.5 V
51.5°
221W1013
l
Adjusting the potentiometer
Lever
Neutral
Potentiometer
NOTE
This potentiometer is not a variable resistor.
So, the shaft does not have the mechanical
stopper (can turn 360 endless) and cannot
measure the resistance by a tester.
NOTE
Apply Alvania Grease or equivalent between
the shaft and the shim and also the surface of
spring.
A
A
221W1015
Shim
Shaft
l
Section A to A
Spring
https://www.forkliftpdfmanuals.com/
