59
5
STEERING
Rece-
ptacle
Tab
(1) Blue
(2) Green/Blue
(3) White
(1) Orange
(2) Green/Red
(3) Black/Red
From EP S
sensor
(potentiometer)
To EPS
cont rolle r
3P water resistant connector
234W026E
Make to the same
value.
2210031
Potentiometer
6. Check the current of the EPS motor doesn't flow at a
neutral position of the steering according to <Checking
procedure> of last page.
5. Adjust for the resistance of above-mentioned B and C
to reach the same value by Shim.
Shim
l
Adjustment of torque sensor neutral
4. Check the resistance between the following pins (tab side).
[Standard value]
l
Between (1) pin (orange) and (3) pin (black and red) = Approx. 5k ...... A
l
Between (1) pin (orange) and (2) pin (green and red) = Approx. 2.5k ... B
l
Between (2) pin (green and red) and (3) pin (black and red) = Approx. 2.5k ...... C
NOTE
Resistance is somewhat different depending on
the kind of the tester.
https://www.forkliftpdfmanuals.com/