33
SERVICE AND MAINTENANCE
1. Remove the reservoir cap, pad and diaphragm for the front brake
(3, 4, 5)
or the reservoir cap
(3)
from
the rear brake pump.
2. Add DOT3 or DOT4 brake fluid from a sealed closed container into the reservoir until the fluid level is
at the MAX mark
(4)
or
(6)
3. Reinstall the reservoir pad, reservoir cap and handlebar cover and tighten the screws
(2)
.
Front Brake inspection
You should check the braking system for breakages and leaks before riding.
1.
Depress the brake lever several times to determine whether there is a leak.
2.
Check the wear condition of the brake pads.
!
ATTENTION:
- The brake fluid must be handled with care, as it can damage the paint surfaces and plastic parts.
- When refilling the brake fluid, make sure the reservoir is set level otherwise fluid will spill out when you remove
the reservoir cap.
- Only use DOT3 or DOT4 brake fluid from a sealed container.
- Do not mix pollutants such as oil, mud or water with the brake fluid in the reservoir.
- Inspect that the fluid level is above the MIN mark, with the motorcycle in a vertical position.
- The brake fluid can cause soreness and inflammation to the skin. Do not allow it to come into contact with your
skin and eyes. If contact is made with the skin, wash it thoroughly with water. If contact is made with the eyes,
wash out with plenty of water and consult a doctor immediately.
- Do not mix different types of brake fluid.
